Most office chairs have a pneumatic cylinder that helps in adjusting the height of the chair according to your need.  Even the best office chair have similar issues as a result of the chair’s pneumatic cylinder gets damaged over a period of your time. Sometimes when few years and sometimes simply when few months of usage. For these reasons, it’s perpetually higher to grasp at first hand – a way to fix your office chair that keeps sinking.

This is going to be a bit technical; however I’ll strive my best to explain within the best and very best way. This gas cylinder of the chair works through pressurized air. This control becomes dysfunctional inside a couple of years, and generally within a few months. Sometimes, it happens as a result of the seals of the cylinder become broken. The air pressure could be a heap to maintain how to Fix an Office Chair that Won’t Stay Up and therefore the seals could not perform well for a long time.

Now, replacement of the cylinder is sort of easy, however you’d need to get a brand-new cylinder for the chair. This can be the best and the least long process that you simply can follow to mend your chair. The cylinder would value you around, however that may definitely prevent a few of hundred bucks if you were to shop for a new chair.

Changing the gas cylinder is quite simple and straightforward process.

Office chairs use a pneumatic cylinder that controls the peak of the chair through pressurized air. The cylinder on most chairs fails inside a couple of years, usually as a result of the seals are too broken to take care of pressure. You’ll get a replacement cylinder to revive full performance to your chair, however, this can be nearly as expensive as shopping for a replacement. Strive these easy DIY methods instead to mend your chair at one convenient height.

1. Slide the plastic skirt of the barrel. Most extendable office chairs have a plastic tube over the extendable barrel. Slide this all the method down or up, till you will be ready to see the metal barrel beneath.

2. SET THE CHAIR TO THE Favored HEIGHT you’ll not be ready to alter the tallness when this repair, thus build on the far side any doubt you’ve it right. The seat of the chair needs to be level along with your knees once you’re standing. If the chair does not stay up even once nobody is thereon, lay it on its aspect. If the plastic skirt covers the barrel at this tallness, you ought to evacuate the skirt, to start with. To do this, flip the chair upside down, thrust the holding clip at the bottom with a screwdriver, and drag off the wheels, at that time the skirt. Slide the wheels back on.

3. Wrap a hose clamp around the cylinder. Get a pair of cm hose clamps (Celebration Clip) from an equipment store. Extricate the screw on the hose clamp (Celebration Clip) and drag out the best conclusion. Wrap the clamp round the metal barrel, but do not fix it, however.

4. Build strides within the grasp of the clamp (prescribed). The clamp will have to be compelled to be exceptionally tight to carry the chair up. Allow the clamp an overseas higher surface to know by wrapping a strip of elastic or one or 2 layers of channel tape round the cylinder.[2] try this at the foremost noteworthy unmistakable purpose on the cylinder, instead, roll up this region of the barrel with sandpaper. If the barrel appearance messy or oily cleans this off, to start with.

5. Fix the clamp as distant as conceivable. Slide the hose clamp to the simplest of the barrel. Twofold confirm the chair is at the correct stature. Drag the hose clamp tight and affix it by pivoting the screw.

6. Take a look at the chair. The chair needs to presently be incapable to slip down past the clamp. The intrinsic stature alteration can still not work lawfully. Within the event that the chair is at the peripheral stature, move the clamp higher or lower on the cylinder. If the clamp slides off, secure it over a strip of elastic to maneuver forward the hold, or try the PVC pipe strategy underneath.

Read also about how to raise an office chair without a lever.